AntennaJet AAS300DP

Bonito AntennaJet AAS300DP

The active antenna splitter AAS300DP splits one antenna lossless to 3 receivers

  • Large dynamic range
  • Wide Frequency range 9kHz -300MHz (- 450MHz*)
  • High intermodulation suppression 
  • High isolation between outputs (>70dB)
  • High reverse isolation
  • Power supply via USB or 12 Volt power source

Bonito’s active antenna signal splitter “AntennaJet AAS300DP” splits the signal from one antenna to three different receivers simultaneously. The AntennaJet AAS300DP has a wideband (>300 MHz) and ultra low noise amplifier and can share one antenna with up to 3 separate receivers which can be tuned to different frequencies without switching the antenna cable or even pressing a button.

Due to the extraordinary high decoupling of the outputs (70dB), interference between the connected receivers is avoided. At the same time, the emission of interference to the antenna is effectively suppressed.

Bonito AAS300DP rear

Up to three receivers can be connected. Non-connected outputs can remain open and don’t need to be terminated. With its ESD-protection circuit the antenna input is protected against short or pulsed voltage surges or short circuits*.

* The ESD Protection does not replace a Lightning protection!

Technical Data AAS300DP

Input frequency range: 9kHz – 300MHz (-1dB) (- 450MHz)
Input connector / Impedance: BNC / 50 Ohms (DC-blocked max. 25V)
ESD-Eingangsschutz: 30KV; max. pulse power 350W (8/20µs)
Maximum allowable input power: 0dBm
Insertion loss: max. 1.5dB typ.
Output connectors / Impedance: BNC / 50 Ohm (DC-blocked max. 25V)
Isolation between the outputs: 70dB typ. <1MHz; 60dB typ. < 30MHz; 50dB typ. <100MHz; 40dB typ. <300MHz
Amplitude difference of the outputs: max. 0.5dB typ.
IP3 Intercept-Point 3rd Order: +35dBm typ. <10MHz; +20dBm typ. >100MHz

All specifications can be change at any time without notice

Power supply: USB-B – Female or 12 Volt power source via barrel connector
Power consumption: max.50mA (5- 12V DC)
Temperature range: 0 – 40°C (without condensation)
Height / Weight: 115 x 90 x 32mm / 0.30kg (4.5 x 3,5x 1.2 in / about 10.5 oz)
Conformity: CE / FCC
Standard-Accessories: USB A/B – Cable (shielded with ferrite core)
Optional Accessories: USB plug – Power Supply (230 / 110 V to 5V DC)

For RX only!

Schon gesehen?

End Fed-Antennen: Tipps & Tricks - Workshop auf der HAM RADIO 2023

End Fed-Antennen: Tipps & Tricks – Workshop auf dem 6. Funktag in Kassel 2024

Auf dem 6. Funktag in Kassel, am Samstag, den 27.4.2024, veranstalten wir einen End Fed …